|
[Sponsors] |
[DesignModeler] Measure the volume of a geometry in ansys geometry modeler |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Abhishek
Join Date: Dec 2010
Posts: 39
Rep Power: 15 ![]() |
Hello all,
Does anyone know how to measure volume of a geometry in ansys modeler? I have a combustion chamber and I need to measure the volume to compute compression ratio. Thanks! |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 13 ![]() |
Hi Abhishek,
Once you click on Body in designmodeler, on the left hand side under "details of body" you can see Volume, Surface area and other things. Other way to see volume and Area is by going to Tools>Analysis Tools> Entity Information. This will help you get details for multiple bodies in your geometry. I hope thts what you are after! Cheers Kapi |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Volume Meshing Problem; YOUR GEOMETRY HAS A HOLE | mariachi | ANSYS Meshing & Geometry | 5 | May 30, 2018 03:52 |
[DesignModeler] How to write the script in the ansys design modeler? | deddy1973 | ANSYS Meshing & Geometry | 3 | October 4, 2013 06:08 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 07:01 |