[ANSYS Meshing] ''Contact sizing'' in 2D Fluent meshing

kaeran · October 20, 2014, 07:30

Hello everone,
I am new to Ansys Fluent and I am facing a ''contact sizing'' problem between a fluid zone and a solid part. In order to analyse accurate heat transfer between a fluid region and the solid part, the interface boundary has to be properly meshed. Attached is the picture showing an improper contact sizing at the interface.

I have also tried contact sizing feature in meshing but I haven't got what I expected.

Please help me with this....

vasava · October 21, 2014, 09:11

Try using 'Match Control'.

Goodstuff · January 30, 2015, 09:53

When I connected two cell zones (both fluid), I opened connections and created a new connection group. Then switched contact to mesh connection, set an appropriate tolerance by means of a slider, and finally, right-clicked at the grop->selected lightning "automatic creation of connections" (i think) and the connection is ready. You could check the connection either by varying the mesh sizes in individual domains and observing, if the stay uniform at the connection region, or by manipulating the display options with regard to the connections. Hope it helps.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with modelling contact in ansys fluent 12.1	mak86	FLUENT	16	August 27, 2019 09:07
problem in using parallel process in fluent 14	aydinkabir88	FLUENT	1	July 10, 2013 02:00
few quesions on ANSYS ICEMCFD and FLUENT	Prakash.Paudel	ANSYS	0	August 12, 2010 12:07
Polyhedra meshing in Fluent 6.1	mireis	FLUENT	1	August 5, 2010 03:42
Meshing problem in fluent	loganathan	FLUENT	2	July 11, 2002 04:16

October 21, 2014, 09:11		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 22	Try using 'Match Control'.

January 30, 2015, 09:53		#3
Goodstuff New Member Gustaw Cegielski Join Date: Dec 2014 Posts: 8 Rep Power: 11	When I connected two cell zones (both fluid), I opened connections and created a new connection group. Then switched contact to mesh connection, set an appropriate tolerance by means of a slider, and finally, right-clicked at the grop->selected lightning "automatic creation of connections" (i think) and the connection is ready. You could check the connection either by varying the mesh sizes in individual domains and observing, if the stay uniform at the connection region, or by manipulating the display options with regard to the connections. Hope it helps.