|
[Sponsors] |
February 3, 2015, 19:07 |
Make periodic boundary in DM
|
#1 |
New Member
amir
Join Date: Dec 2012
Posts: 29
Rep Power: 13 |
Hi dear friends
I want to model flow over a vane. My problem is making periodic boundary for it. please help me about it. How can i create periodic boundary in DM? Fluid domain and Vane have been shown in Fig. Thanks |
|
February 4, 2015, 03:29 |
|
#2 |
Senior Member
|
Create one of the boundaries, for example by sketch and extrude, then rotate and copy it the amount of degrees that is needed. Then make the cut using those to surface bodies and you should have a periodic domain
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
[swak4Foam] some errors in compiling groovyBC in OF220 | immortality | OpenFOAM Community Contributions | 10 | April 1, 2013 04:46 |
problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 29, 2010 00:32 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |