[andrei93]

I have made a mesh with ansys meshing, with follow properties:
- the geometry was imported from solidworks with an iges file;
- the mesh was created with meshing tool from workbench;
- the properties of mesh are:
- method - hex dominant;
- mapped - on both surfaces;
- size: on both edges from up and down faces;
- size: along the bar;
- I have saved the mesh file .icem extension. Afther that I have opened in icem cfd model. What I want to do? I want to create my part in Autodyn. I have made also the .k file from Icem Cfd model and when I want to import .k file to autodyn, the part doesn't want to appear.... I have obtained only a small part from my bar.
If you have an idea about my errors or to make this import on the other way, please tell me!
Thank you very much!
I have attached the picture from mesh model and from autodyn after imported the .k file.

[andrei93]

I have tried to sketch the geometry in the geometry tool from Ansys Workbench and I have obtained the same result: the geometry doesn't appear complete (missing some parts).