[teo88]

Hi all!!

I create in solidworks my 2D model with the coordinate system center in the middle of the wheel.
When I import it in ANSYS, the center of the Cartesian system is not perfectly in the center of the wheel, in fact, if I create a new reference system, this is shifted by little as you can see in the pictures.

This is a problem when I go to simulate with fluent, in fact the rotating zone is detached from the fixed area.

Is there a way to change the global coordinate system, or to import exactly solidworks model?

Than you

[sifet]

Hi
Did you try geometry»properties»import geometry coordinate system
Best wishes

[teo88]

yes but it's the same

[Ranjith Kumar J]

Someone please please please tell how to change the global coordinate system
Im dying here for answer.