[ICEM] Asking to explain a simple concept when blocking and meshing.

catalysthw · June 11, 2015, 17:53

Hello, ICEM experts.

I'm trying to make boundary conditions on my model by using ICEM.
But, there are something I need to understand.
After model geometry, I assigned blocks to make hexahedron mesh on my geometry and then a part 'SOLID' was made.

Could you exactly explain what is 'SOLID'?
Is it right that 'SOLID' represent the inner volume?

https://www.dropbox.com/sh/hpaq13zfg...YraP-Jkma?dl=0

Thanks for your interest!

Sincerely,
Hyowon Lee

shereez234 · June 12, 2015, 12:52

That is correct. Generally if it is solid it means inner volume and you delete it at the end of meshing before export.

June 11, 2015, 17:53	Asking to explain a simple concept when blocking and meshing.	#1
catalysthw New Member Hyowon Lee Join Date: Feb 2013 Location: Ulsan, South Korea Posts: 11 Rep Power: 13	Hello, ICEM experts. I'm trying to make boundary conditions on my model by using ICEM. But, there are something I need to understand. After model geometry, I assigned blocks to make hexahedron mesh on my geometry and then a part 'SOLID' was made. Could you exactly explain what is 'SOLID'? Is it right that 'SOLID' represent the inner volume? https://www.dropbox.com/sh/hpaq13zfg...YraP-Jkma?dl=0 Thanks for your interest! Sincerely, Hyowon Lee

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Blocking and Meshing around a vane vortex generator	Crank-Shaft	ANSYS Meshing & Geometry	5	January 17, 2016 23:29
[ICEM] Blocking Strategy For a simple Box	Tarantino	ANSYS Meshing & Geometry	6	February 3, 2013 08:15
[ANSYS Meshing] Blocking and Meshing Strategy for an open flow domain over backward facing ramp	Crank-Shaft	ANSYS Meshing & Geometry	0	January 11, 2013 05:48
[ICEM] Hexa meshing blocking problem	fergal	ANSYS Meshing & Geometry	0	June 28, 2011 10:01
[ICEM] Simple Meshing (w/o blocking)	shohin	ANSYS Meshing & Geometry	7	May 25, 2010 04:23

June 12, 2015, 12:52		#2
shereez234 Senior Member M Sereez Join Date: Jan 2014 Location: England Posts: 352 Blog Entries: 1 Rep Power: 13	That is correct. Generally if it is solid it means inner volume and you delete it at the end of meshing before export.