|June 17, 2015, 04:48||
too many fins, how to auto associate.
Join Date: Jun 2012
Location: Torino, Italy
Posts: 701Rep Power: 8
This is a 2D case.
This is my geo, lots of fins,
I made blocks like this, premesh is acceptable.
But I have problems to assiciate it to the curves, I tried "auto associate" in blocks panel, I also tried with "associate mesh with geometry" all does not work. Is there a quick way to deal with this?
Im the translator of OpenFOAM User Guide Chinese Edition! But always newbie on CFD.
Never too old to learn CFD. Worship these CFD experts.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[DesignModeler] Having problems with heat-exchange fins - all details to recreate are provided||Linums||ANSYS Meshing & Geometry||7||November 13, 2014 11:12|
|Heat Sink Meshing||Olds88||Pointwise & Gridgen||13||July 28, 2014 23:30|
|Heat transfer from a heated plate using fins||pathakamit||FLUENT||1||April 30, 2013 04:07|
|Best Association Practice for 3D meshing w/ICEM (associate edge, face, vertices..?)||scribby182||ANSYS||6||April 15, 2013 11:55|
|[ICEM] Blocking topology for cruciform fins||siw||ANSYS Meshing & Geometry||22||September 6, 2012 04:55|