|
[Sponsors] |
July 21, 2015, 17:11 |
Quality Mesh Discussion
|
#1 |
Member
Massachusetts
Join Date: Jun 2015
Posts: 46
Rep Power: 10 |
Hello to all,
I'm going to make my first 3D simulation of a F3 front wing, and i'm watching some videos on youtube showing how to use ansys meshing. I saw this two tutorial https://www.youtube.com/watch?v=kuEqlSmyAos https://www.youtube.com/watch?v=ZDWvZ6UO0hI However i'm not sure the quality of the mesh obtained is good, and i think the results from the simulation will not be realistic. am i right thinking so? do you know a video tutorial that explaines what i need? Thanks for help |
|
July 21, 2015, 18:58 |
|
#2 |
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13 |
the 2nd video is better, the 1st one ... well i have no words...
Try some meshing tutorials. Tet mesh without inflation is absolutely no good... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[snappyHexMesh] Improving mesh quality + inlet too coarse | MartinBlx | OpenFOAM Meshing & Mesh Conversion | 5 | August 2, 2015 22:09 |
[Other] Mesh quality | vitorspadetoventurin | OpenFOAM Meshing & Mesh Conversion | 0 | November 28, 2014 18:27 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
Quality of extruded mesh in ICEM CFD | Andrew | CFX | 1 | December 28, 2006 10:35 |