[nikesh]

Hello folks,
I have been trying for weeks to come up with a blocking strategy to mesh this beauty (Fig1).
Fig2 shows the entire computational domain. Fig3 is where I have tangled, like stuck in a spider web soon to be its feast.
Fig4: The connector region is so difficult to block. I haven't figured out a way to block it, especially because it is connected both to the main and tail wings and goes normal to the wing surface.
Fig5: The tail which has anhedral angle and goes from the top of the vertical fin to the connector.
Fig6: Wing-fuselage joint section has similar geometry to that of the connector region and I believe has the same solution to that of Fig4.

Any help highly appreciated.
Thanks a lot.
Nikesh.

[nikesh]

Here comes Fig6.