CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] How to resolve my error in Design modeler? (https://www.cfd-online.com/Forums/ansys-meshing/158674-how-resolve-my-error-design-modeler.html)

siamak1438 September 1, 2015 03:20
How to resolve my error in Design modeler?
 
1 Attachment(s)
Hi all,
Do you know how can I get rid of this error? When I open the design modeller it shows the error"ag.gui.setUnit Large mode on" and then crashed and close automatically. It made me crazy in these days. Please help me :eek::confused::
(I attached screenshot)

jrunsten September 2, 2015 08:44
Perhaps this can help.
In designmodeller, before you import anything, try swithing this on or off.

http://i.imgur.com/bTrlc8C.png

siamak1438 September 2, 2015 23:41
Quote:
Originally Posted by jrunsten (Post 562155)
Perhaps this can help.
In designmodeller, before you import anything, try swithing this on or off.

http://i.imgur.com/bTrlc8C.png
No your solution is not working Jrunsten. In fact, I cannot open the mechanical editor to change any setting there. It crashes immediately after opening. However, I contact to support center in Australia and they advised me to do the following instruction. I did it and now, it is working.
"close ANSYS & rename the directory %AppData%\Ansys to ANSYS_OLD"

Kapi September 3, 2015 02:07
Siamak,

Sometimes DM gets corrupted and those bug are hard to get off
By renaming current directory you are basically creating a Fresh Directory without bugs. It has happened to me as well.
Hope it works out now

Cheers
KAPI


All times are GMT -4. The time now is 04:18.