|
[Sponsors] |
[GAMBIT] Unable to allocate XXXX bytes of dymamic memory |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 15, 2015, 07:11 |
Unable to allocate XXXX bytes of dymamic memory
|
#1 |
Member
wanghuo
Join Date: Aug 2014
Posts: 89
Rep Power: 11 |
Hello friends!
When I was using the gambit ,it often prompt"Unable to allocate XXXX bytes of dymamic memory" .Instead of volume decomposition (split) is there any tips to resolve this problem?Thank you very much! hotboy |
|
September 15, 2015, 07:19 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
you are trying to mesh something fine which requires lots of ram memory.
I would divide your domain into several subdomains
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 15, 2015, 07:35 |
|
#3 |
Member
wanghuo
Join Date: Aug 2014
Posts: 89
Rep Power: 11 |
||
September 15, 2015, 07:48 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
or you can try to mesh coarser
can you display your geometry?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 15, 2015, 07:58 |
|
#5 |
Member
wanghuo
Join Date: Aug 2014
Posts: 89
Rep Power: 11 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ERROR: Unable to allocate 45256392 bytes of dynamic memory. | eespi002 | ANSYS Meshing & Geometry | 15 | October 27, 2010 13:38 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Cannot allocate memory for arrays (1400,1000) | Quarkz | Main CFD Forum | 5 | January 27, 2008 06:38 |
Gambit unable to allocate dynamic memory | Abhijeet Karnik | FLUENT | 0 | October 2, 2006 12:59 |
CFX CPU time & real time | Nick Strantzias | CFX | 8 | July 23, 2006 17:50 |