CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] Unable to allocate XXXX bytes of dymamic memory (https://www.cfd-online.com/Forums/ansys-meshing/159434-unable-allocate-xxxx-bytes-dymamic-memory.html)

hotboy September 15, 2015 07:11
Unable to allocate XXXX bytes of dymamic memory
 
Hello friends!

When I was using the gambit ,it often prompt"Unable to allocate XXXX bytes of dymamic memory" .Instead of volume decomposition (split) is there any tips to resolve this problem?Thank you very much!

hotboy

-mAx- September 15, 2015 07:19
you are trying to mesh something fine which requires lots of ram memory.
I would divide your domain into several subdomains

hotboy September 15, 2015 07:35
Quote:
Originally Posted by -mAx- (Post 564058)
you are trying to mesh something fine which requires lots of ram memory.
I would divide your domain into several subdomains
There is no any other tip to resolve this problem except for divide the domain into several subdomains or update the hardware?

-mAx- September 15, 2015 07:48
or you can try to mesh coarser
can you display your geometry?

hotboy September 15, 2015 07:58
Quote:
Originally Posted by -mAx- (Post 564065)
or you can try to mesh coarser
can you display your geometry?
Dear mAx!
Thank you very much for your reply .


All times are GMT -4. The time now is 21:57.