Regular meshing
 

Hi folks, this is my first thread, but the forum has helped me a lot! I'm at my first steps with Ansys.

I have a diferential volume that I want to mesh. I want to mesh the superior face and then "extrude" this mesh all the height of the volume in a regular way, 10 layers.

http://i.imgur.com/jskfLVs.png
This is similar to I want to get

I tried with an edge sizing, it looks good on the exterior, but when I apply the inflation for the wall function, it ends all messy and untidy, also the mesh is not regular on the inside.

http://i.imgur.com/cJAqsER.png
This is what I get when I apply inflation

I also tried using mapped face meshing, it looks, more regular, but again only in the edges.

http://i.imgur.com/dUQCXXm.png
This with maped face meshing

How can I solve this?

Thanks, and sorry for the bad English.