[Workbench] Mesh control far from boundaries

Beginner_CFX · July 5, 2016, 16:40

Hello everyone
I need to add at the center of a volume, on a plane crossing the entire volume a height of volumetric elements finer than up and down. The plane doesn't exist in the gemometry, it is a location that I shose.
I want to have a kind of inflation but at the center of the volume, not at the boundaries.
Does someone can help me, please?

Thanks

diamondx · July 5, 2016, 19:03

Well, in ICEM , you will still need to add a surface (plane) and give it the inflation you want. then declare it as interior when you export the mesh.

Beginner_CFX · July 6, 2016, 11:52

Thank you Ali,
Is IEM is the same like the mesh application when I am using "Fluid Mechanics (CFX)»?
I separated my geometry on 2 parts, I did Named selection from where I need fine mesh. In mesh application, I am trying to gather the 2 parts into only one. I am facing some difficulties. Can you give me some giddiness please?

July 5, 2016, 16:40	Mesh control far from boundaries	#1
Beginner_CFX New Member Join Date: Feb 2016 Posts: 6 Rep Power: 10	Hello everyone I need to add at the center of a volume, on a plane crossing the entire volume a height of volumetric elements finer than up and down. The plane doesn't exist in the gemometry, it is a location that I shose. I want to have a kind of inflation but at the center of the volume, not at the boundaries. Does someone can help me, please? Thanks

July 5, 2016, 19:03		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	Well, in ICEM , you will still need to add a surface (plane) and give it the inflation you want. then declare it as interior when you export the mesh. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Ansys CFX exited with return code 1.	dheelibun	CFX	8	May 7, 2014 07:21
[ANSYS Meshing] Workbench 14: Mesh Control	dstrunner	ANSYS Meshing & Geometry	2	May 2, 2013 08:05
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

July 6, 2016, 11:52		#3
Beginner_CFX New Member Join Date: Feb 2016 Posts: 6 Rep Power: 10	Thank you Ali, Is IEM is the same like the mesh application when I am using "Fluid Mechanics (CFX)»? I separated my geometry on 2 parts, I did Named selection from where I need fine mesh. In mesh application, I am trying to gather the 2 parts into only one. I am facing some difficulties. Can you give me some giddiness please?