|
[Sponsors] |
December 7, 2015, 13:33 |
component out of a scetch
|
#1 |
Senior Member
Join Date: Nov 2015
Posts: 135
Rep Power: 10 |
Hello,
The picture underneath shows 2 circles. The outer circle was used for Außenhaut/Ausformung (I dont know the english word) and the other I wanted to use to specify a component region. Though, how do I do that? I havent really figured it out...The way I did it here is I used surface through scetch (Oberflächen durch Skizzen). But this gives me an entire new body (Schalenkörper) additionally to Volumenkörper (volumebody?) which is not correct or? What I also noticed is that even though I specify the new "surface through scetch" as a new component, when selecting it in fluent it chooses the entire region of the bigger circle!? So how can I properly define a component region within an already given surface bordered by the outer circle? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error message: Insufficient Catalogue Size | Paresh Jain | CFX | 32 | February 3, 2021 03:37 |
Momentum source coefficient, cylindrical coordinates, circumferential component? | polakse | CFX | 15 | January 18, 2016 02:40 |
---y component of velocity i.e. V velocity | mech | FLUENT | 1 | May 26, 2006 11:32 |
Diffusion component at inlet | Balaji | FLUENT | 2 | August 8, 2005 07:37 |
UDF component in Cyliderical Velocity? | Hongchan Kim | FLUENT | 3 | April 24, 2001 12:20 |