CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [GAMBIT] Gambit to open and old msh file (

Muntasir February 24, 2009 13:25

Gambit to open and old msh file
Hi, can somoebody tell me how to use GAMBIT to re-open an old mesh file that i've created by GAMBIT. I've tried a lot.

Balduin Bankerotti February 24, 2009 18:19

re: Gambit to open and old msh file
Might you please ask your question in the fluent forum.

Muntasir February 25, 2009 00:55

re: Gambit to open and old msh file
Sorry for all, i thought that the msg have been posted in Fluent forum.

shubham208011 March 26, 2009 15:13

ya you can..
go to file menu then select import mesh then select the version of like fluent5/6etc
then type like 3d or 2d then browse the mesh file n click open..

saharesobh August 1, 2012 15:25

Hi. I have one question. Actually I am working with Ansys Fluent 13. and I meshed my model via Ansys Fluent . But I am going to change the boundary condition. I cannot go back to mesh set up. because the mesh filed was sent to me by my advisor. but you know, when I go to set up part in Ansys Fluent, file, mesh, gambit,,,,
I mean in set up I have gambit. but I don't know how to open my case file or mesh file in gambit in Ansys Fluent 13. Would you please give me some advise. Just to mention I don't have gambit in my laptop. I have just Ansys FLuent 13.

Marion August 2, 2012 02:21

If you have workbench, you should probably use Design Modeller and Ansys Meshing for this.

What do you want to change on your boundary condition?

And, for the record: you cannot "have meshed your model via Ansys Fluent" - Fluent is not a meshing software.

All times are GMT -4. The time now is 03:40.