 |
 |
 |
|
|
|
[Sponsors] | ||||
December 28, 2015, 04:32
|
Structural Mesh on Compressor
|
#1 |
|
New Member
Noukhez Ahmed
Join Date: Mar 2014
Posts: 9
Rep Power: 12  |
Dear All,
I am working with centrifugal compressor stage. I have used blocking method to put mesh on diffuser part of centrifgual compressor stage. The mesh look fine, but when I go and look at the quality of the mesh, it shows the element having uality ever lower than 1, as shown in the attached figure. Furthermore, the aspect ratio is higher 5 in thousands. Can anyone please advise, what step shall I choose to improve the quality. I am very much struglling. Ansys CFX is accepting this kind of mesh. I have attached few figures that might help in elaborating the respected request. Please help!!! Many thanks, |
|
|
|
|
|
December 29, 2015, 19:36
|
|
#2 |
|
New Member
Noukhez Ahmed
Join Date: Mar 2014
Posts: 9
Rep Power: 12 |
Can anyone please help with the aforementioned thread.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Linear Mode
