need help
5 Attachment(s)
Hello, guys
I am a graduate student working on the ANSYS CFD project for my master thesis, now i have several problems about my project, hope some experienced engineer could help me, so I can graduate 1, this is my structure with highly curved face and small gap inside any one can give me some instructions about making a better mesh , ansys workbench does not help now, i tried millions time, still cannot get a decent mesh |
One of the ways could be, to try and apply variety of local meshes at different regions by dividing your flow domain into parts..later on interface these regions in Fluent/ CFX..
|
thx, this seems the only way,
I tried the ICEM CFD, however I cannot deal with this kind structure by using ICEM |
in my opinion, you should create seperate regions where you can use different types of meshing, then you can smoothen/swap the mesh....
|
All times are GMT -4. The time now is 17:07. |