|
[Sponsors] |
[ICEM] Exporting turbomachinery stage-fluid-zone into ICEM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 20, 2016, 20:05 |
Exporting turbomachinery stage-fluid-zone into ICEM
|
#1 |
New Member
m
Join Date: Mar 2016
Posts: 13
Rep Power: 10 |
I 've done my rotor and stator design in blade design modeler and specified the flowpath and the stage-fluid-zone but after i exported it to ICEM ,it gives me the whole geometry of the rotor and stator for the whole number of blades.
MY question is: Is there any way to export only the stage-fluid-zone of one rotor and stator into ICEM instead of the whole goemetry |
|
March 21, 2016, 15:04 |
|
#3 |
New Member
m
Join Date: Mar 2016
Posts: 13
Rep Power: 10 |
Thanks for replying,,,After exporting the whole geometry, i delete the other rotor and stator blades from the solid left tree except the three blades in the stage-fluid-zone . I think it's going to work now . Icem shows me now only the stage -fluid -zone
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
Error in solution using "Grid Interface" | agustinvo | FLUENT | 4 | January 20, 2015 12:03 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
How to specify energy source in a fluid zone? | abong | FLUENT | 0 | February 17, 2005 02:15 |
how to define a local zone in whole fluid zone? | Lcw | FLUENT | 3 | September 21, 2004 08:33 |