 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] How to perform a local cut of the geometry ? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 3, 2016, 10:49
|
How to perform a local cut of the geometry ?
|
#1 |
|
New Member
Join Date: Jun 2016
Posts: 1
Rep Power: 0  |
Hello everyone,
I'm quite new with ANSYS and design modeler. I'm working on a model of the arterial system. I want to divide my geometry in different parts. I tried using slice, the problem is that the slice function cut through the whole geometry. Is it possible to perform a local cut of my geometry without cutting the other arteries? For exemple is it possible to divide my geometry as shown on the picture below? Thanks! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 16, 2019 23:12 |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
| InterFoam negative alpha | karasa03 | OpenFOAM | 7 | December 12, 2013 03:41 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
| Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Linear Mode
