|
[Sponsors] |
August 21, 2016, 13:28 |
how to give nodes
|
#1 |
New Member
ANKUR GUPTA
Join Date: Jul 2016
Location: CHENNAI, INDIA
Posts: 11
Rep Power: 9 |
Hello,everybody, I am facing a problem in meshing.. plz help me out
Problem: Flow between parallel plates the distance between plates=2 cm non-uniform grid= 0.5 mm up to 4 mm from wall = 2 mm up to c-line from above |
|
August 23, 2016, 03:24 |
|
#2 |
Senior Member
Sebastian Engel
Join Date: Jun 2011
Location: Germany
Posts: 566
Rep Power: 20 |
Hello Ankur,
you might have forgotten to explain your actual problem which needs help. Have a look at this thread http://www.cfd-online.com/Forums/ans...wers-here.html In case you haven't done them before, I strongly suggest you to do the tutorials which come with icem. With regards, Sebastian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
32 Cores Mini-Cluster, 2 Nodes vs. 4 Nodes performance | Courageous | Hardware | 3 | July 7, 2016 11:37 |
How To find values between nodes in finite element | joseph11554 | Main CFD Forum | 1 | December 28, 2015 10:26 |
[ICEM] Edge Spacing Doesn't Propagate through Equal-Radius Hex Mesh Nodes of Cylinder | hebush | ANSYS Meshing & Geometry | 3 | November 6, 2015 10:12 |
[ICEM] Very weird, pre-mesh does not generate volume mesh after setting nodes on some edge. | sharonyue | ANSYS Meshing & Geometry | 0 | April 30, 2015 12:06 |
Viewing all nodes in a plane | kajal | ANSYS | 1 | May 20, 2011 13:13 |