 |
 |
 |
|
|
|
[Sponsors] | ||||
May 20, 2009, 06:16
|
Meshing a Triangular part
|
#1 |
|
New Member
Waseem
Join Date: May 2009
Posts: 12
Rep Power: 16  |
Hello
I am trying to generate a structured mesh for a triangular part. The problem is that bocking I do is resulting in very complex pre-mesh. All lines tends to pass through the vertice resulting in very dense mesh near that vertice. A snap is attached also. What you suggest I should do? Waseem |
|
|
|
|
|
May 22, 2009, 12:43
|
QUarter Ogrid or Y block...
|
#2 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
WHat you need is a quarter ogrid or Yblock...
I have quickly created and attached a short ppt that should show you the steps. There are lots of ways to get this done, but this one is the most general. It can be done in 2D or 3D. Simon |
|
|
|
|
|
|
May 22, 2009, 12:46
|
|
#4 |
|
New Member
Waseem
Join Date: May 2009
Posts: 12
Rep Power: 16 |
Thanks Brother
I will try it.... Thanks again... Waseem |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing of very complicated part | Sanjay Jain | FLUENT | 9 | April 7, 2009 00:21 |
| meshing triangular channel | mu | FLUENT | 3 | February 22, 2008 11:31 |
| Please help me to meshing 3D triangular channal | rosol | FLUENT | 1 | September 7, 2007 16:52 |
| meshing hollow part of pipe | rai | FLUENT | 0 | December 19, 2005 00:46 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
