CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Check the skewnesses of your face meshes and make sure the face mesh sizes are not to (http://www.cfd-online.com/Forums/ansys-meshing/63584-check-skewnesses-your-face-meshes-make-sure-face-mesh-sizes-not.html)

sophie-l April 13, 2009 17:27

Check the skewnesses of your face meshes and make sure the face mesh sizes are not to
 
hi,
i am trying to mesh a big cylinder with an other small one that is tangentiel to the first. I can mesh the big one without problems, but when i try to mesh the small one the following message of error is given by gambit:
Check the skewnesses of your face meshes and make sure the face mesh sizes are not too large in areas of samll gaps

what should i do?
thanks
sophie


All times are GMT -4. The time now is 13:22.