CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] Clean up of face duplicate (http://www.cfd-online.com/Forums/ansys-meshing/64258-clean-up-face-duplicate.html)

shg74 May 5, 2009 09:48

Clean up of face duplicate
 
1- I copied some volumes with linked mesh and zone types.
2- These volumes now have adjacent faces (e.g. In below figure, face 1 and face 2).
3- When I try to clean up these duplicated faces, a fatal error terminates Gambit.
4- Meanwhile, I cleaned up all the duplicated edges and vertices.
5- I could copy the volumes without linked mesh and remove all duplicates.
Could you please help on this matter? Because I can not mesh this volume with more than 13000 edges, 8000 faces and 800 volumes.
6- what will be happened, If I copy volumes with unlinkmesh? Because I have done it, and no errors occured?

-----------..--------------
|...............||..................|
|......Face1.||.Face 2........|
|...............||..................|
|...............||..................|
-----------..--------------
.Volume1...........Volume2.


All times are GMT -4. The time now is 10:47.