|
[Sponsors] |
June 11, 2009, 17:51 |
3D Boundary Layer Help!!
|
#1 |
Member
Join Date: Mar 2009
Location: Texas
Posts: 33
Rep Power: 17 |
I am trying to use a 3D boundary layer on this section of pipe (as shown in the figure). I want to use a hex mesh here with the same expansion rate as the boundary layer mesh. I've tried unsuccesfully to use a size function (using "meshed") to control the mesh size on the top surface of the little horseshoe volume and on the edges. I think part of the problem is I can't figure out what the best "source" and attachment features to use for my size function. Does anyone have any suggestions on what I could try. Thanks in advance!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Default Faces on Boundary Layer | axel | OpenFOAM Meshing & Mesh Conversion | 8 | February 17, 2011 07:47 |
Adapt mesh without modifying boundary layer cells? | Freeman | FLUENT | 0 | February 22, 2009 14:11 |
3D Boundary Layer | Mario | FLUENT | 0 | February 17, 2009 03:40 |
Adding layer to cyclic boundary | Chris P | Siemens | 3 | November 15, 2004 21:17 |
boundary layer simulation : basic issues | amol palekar | Main CFD Forum | 0 | July 27, 2004 18:22 |