Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

How to creat the impeller leading edge

Mark Forums Read

Reply

Search this Thread

June 13, 2009, 02:54	How to creat the impeller leading edge	#1
Jasmine Member ^_^ Join Date: Mar 2009 Posts: 36 Rep Power: 17	The data for pressure side and suction side are available. But for the leading edge only the blade LE inclination angle is given. How should I create the LE? thanks for any suggestion.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Leading edge separation and efficiency	KK	Main CFD Forum	2	December 3, 2008 06:19
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Airfoil "Near Leading Edge" Heat Transfer question	Glenn	CFX	1	July 7, 2007 06:47
Airfoil Heat Transfer Near Leading Edge	Glenn	Main CFD Forum	0	June 28, 2007 12:53
Airfoil Leading Edge Heat Transfer	Glenn	FLUENT	0	June 27, 2007 13:57

All times are GMT -4. The time now is 04:22.