|
[Sponsors] |
June 11, 2009, 16:21 |
high oscillation warning??
|
#1 | |
Member
Join Date: Mar 2009
Location: Texas
Posts: 33
Rep Power: 17 |
I've been meshing a pipe that has some rectangular orifices along its span. My initial cell heights in the orifices is 0.001 (to give a good y+ number). When I save my mesh, I get the following warning:
Quote:
|
||
June 15, 2009, 06:48 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
It's just a warning, if your mesh isn't disturbed, then ignore it.
Try to mesh the surface which is attached to this edge, and observe if you have something weird
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 06:59 |
OpenFOAM14 for Mac OSX Darwin 104 | gschaider | OpenFOAM Installation | 118 | July 20, 2008 05:19 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |