CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] 3D elbow (http://www.cfd-online.com/Forums/ansys-meshing/65731-3d-elbow.html)

nmonnier June 24, 2009 10:06

3D elbow
 
hi
I have tried to design a 3D elbow in gambit with instructions found on the site
1 circular face
2 draw an hyperbol starting from the centre of the circular face
3 sweep circular face along the edge
but it does not work i have a error message writing that face and edge have common points ...
If anyone could help me !
I think i willpost another thread for the meshing !
thanks a lot
gambitly yours,
nathalie

-mAx- June 25, 2009 01:23

copy your edge and re-try with the edge you just created with copy (face and edge will be separated)

nmonnier June 25, 2009 08:36

always problems
 
thanks max,

I have tried what you wrote. But there are still problems remaining. I have the same error message telling me that the face and edge path are parallel ??
If someone has any idea .. thanks
Nathalie

-mAx- June 25, 2009 10:22

this isn't the same error message.
Now your face and the edge are on same plane?
Just copy your edge with translation (give an translation, else both edges will be superposed)


All times are GMT -4. The time now is 19:38.