|
[Sponsors] |
August 5, 2009, 11:42 |
Non-confirmal meshing.....
|
#1 |
Member
Devesh Baghel
Join Date: Mar 2009
Posts: 84
Rep Power: 17 |
Hi all,
I have one cyinder of dia 0.5 m & of length 5 m. I want to do Non-confirmal mesh from the mid of cyinder. I tried by spliting the face, but not getting the solution. can any body please help me ? |
|
August 6, 2009, 02:36 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
For a non conformal mesh, you need an interface where 2 different kinds of mesh are superposed.
That means you need to plit your volume, BUT you also need to deconnect the 2 volumes.
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
doubt on meshing | joe | FLUENT | 2 | September 12, 2005 13:17 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |