CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Splitting edge of block (http://www.cfd-online.com/Forums/ansys-meshing/67944-splitting-edge-block.html)

rwryne September 1, 2009 10:52

Splitting edge of block
 
Hi all:

I had a quick question about splitting the edge of blocks with Auto-pick mode turned on in ICEM v11

Occasionally if I have auto pick mode ON and am using the Prescribed Point split method, when I select an edge it automatically picks a point. From my understanding of auto-pick mode, it should automatically prompt me to pick a point, not select one for me.

As it stands, I always have to turn off auto-pick mode to split block edges, which is an annoyance. Any insight into this problem?

Thanks in advance,

Ryne


All times are GMT -4. The time now is 03:03.