[holyo]

Hello again, I´ve a problem, my middle button seems doesn´t work, in some operations I have to press for accept the selection of curves (for example), when I do it, the selection desappears. What can I do?

Thank you.

[PSYMN]

If you don't have a middle mouse button (such as on a laptop), you can click left and right buttons simultaneously. I have always found that too awkward to work with though.

Are you saying your mouse just doesn't work properly or that ICEM CFD is not properly recognizing the mmb?

If it is the mouse, I recommend a new mouse. If it is the software, that is the first I have heard of this problem... Please give more details. Is it a specific command or every command? What is happening?

[holyo]

Hello, I´m going to explain my problem.

I´m doing the tutorial that describes how to repair the geometry.

I have to remove a hole, the tutorial´s steps are:

–Select any one of the boundary curves on the hole

–Press “l” (lower case L) on the keyboard or Select all items attached to current selection in the Select geometry toolbar

–Selects all curves tangentially attached to the selected curve (“flood fill”)

–Selection restricted to yellow (single edge ) curves

–Middle mouse, then hit Apply

–Press “y” to accept the surface

When I press the middle mouse (in my mouse is a wheel), the selection desappears.

I change the mouse and I had the same problem. I try to pulse left/right buttons at the same time but nothing changed.

[PSYMN]

When you use this command, the middle mouse button ends the selection.

Then it switches to preview mode. If your background is set to black, this is easiest to see. It asks you to select "y" or "n".

If you select yes, then it creates the surface.

When you hit the middle mouse button (I also have a wheel mouse on Windows), does it ask you for "y" or "n"?

What happens when you select "y" or "n"?

[holyo]

Thank you for your help, now I don´t have the problem because I changed my mouse.

Thank you again.

[PSYMN]

Great...

Thanks for letting us know how the story ended.

[reza.sayareh]

hi guys, i am using ICEM 2020, while i want to rotate by holding left mouse bottom it goes to creating point directly .pls help

[silambarasan7]

Change the mouse settings in ICEM software