CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   cfx mesh error msg 2 (http://www.cfd-online.com/Forums/ansys-meshing/69807-cfx-mesh-error-msg-2-a.html)

mactech001 November 5, 2009 06:35

cfx mesh error msg 2
 
Hi all,

i was prompted the following error from CFX-mesh:

Internal Error
No boundary edge found.
The surface may be highly curved and mesh resolution may be poor. Try reducing the mesh spacing on the problem surface and retry.
The face contains singular points
The parametrization of the face is poor in the region of these points. Try modifying the model to improve the parametization of this face.

But no area on my model was highlighted......

How can further diagnose this error please?

Thanks for your kind attention. hope to receive your comments/suggestions.

Regards,
mactech001


All times are GMT -4. The time now is 19:55.