CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Named selection - design modeler (http://www.cfd-online.com/Forums/ansys-meshing/70285-named-selection-design-modeler.html)

jsm November 19, 2009 08:44

Named selection - design modeler
 
Hi,

In design modeler, I modeled two volumes that are connected. One volume is bigger than another. I am going to solve this model in Fluent. I want to give interior boundary condition between these volumes. But I could not give through named selection due to different face sizes. How to give the named selection for this kind of situation?


All times are GMT -4. The time now is 03:53.