|November 21, 2009, 08:16||
Different Types of meshing
I have a question about using different sorts of meshes in Gambit.
I want to split up a face in 4 different faces. In 2 faces i want to use a Tri - Pave mesh and in the 2 others a Quad - Map mesh.
In front and aft of the 'boat' i should use a Quad - map mesh for a good resolution of the free water surface. All the rest doenst really matter so i use a tri mesh.
The boat is substracted from the Flow Volume and the meshing is ok. But when i export te mesh, Gambit makes a (default) wall BC of the edges 1-4 (colored in red)
So what should i do so i can split up the face for an optimal meshing but without this wall BC?
any help is appreciated!!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|
|Is conformal meshing really an advantage?||Alvin Szeto||Main CFD Forum||19||June 27, 2003 07:23|