CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] how to managing quality type of meshing?? (http://www.cfd-online.com/Forums/ansys-meshing/71274-how-managing-quality-type-meshing.html)

teguhtf December 22, 2009 19:51

how to managing quality type of meshing??
 
Hi everybody!!!
I'm confused in managing the quality of my meshing. I have bad at equiangle skew (it's higher than 0.9). After i repair it, the value of equiangle skew become less than 0.9 but there are other problems. the value of equisize skew become higher than 0.95. What should i do??
Is any body know the good value of Area, aspect ratio, edge ratio, equiangle skew and equisize skew??
Do you have reference??
Thank you!!
teguhtf:)


All times are GMT -4. The time now is 09:16.