workbench and control mesh with y+
How I can control y+ in workbench as I do meshing?
I need it for CFX
You don't mention a particular mesher...
I asked John Stokes@CFX about it and he sent me this chunk from the CFX-Mesh manual...
Look it up in the manual.
So if you are using CFX-mesh, open up the help and look for Y+. You will find a section on it.
Actually, you could use that simple equation manually if you like and enter the calculated first cell height into any mesher... ;)
Sorry for the three posts instead of 1.
realy appreciate your help and advice
I read your post recently so I will read it and come back
|All times are GMT -4. The time now is 20:40.|