|January 19, 2010, 09:14||
Pressure inlet BC Fluent?
Join Date: Aug 2009
Posts: 36Rep Power: 9
Hi, i have a doubt.
I have a catalytic converter and i must set pressure inlet. I have between inlet and outlet a difference pressure of 800 mmH20=78400 Pa. How do i set total gauge pressure?
|February 25, 2010, 09:09||
different meshes -> different results in FLUENT
Join Date: Nov 2009
Posts: 8Rep Power: 8
I'd like like to do an meshing analyzation of a steam turbine gasket. That means, I would like to do do several meshes in the ANSYS 12 mesher.
The meshes should be from very fine to very coarse. The cells are triangles. For each mesh I will start a calculation in FLUENT.
The aim is to see how the results of the calculations diverge if I change the mesh.
How can I create several meshes out of one?
Or how can I change one mesh and save the different calculations in FLUENT?
It'd be nice if anybody could help me.
@jackr84: 1)open fluent->boundary conditions->click on 'pressure-inlet'->Momentum-> gauge pressure-> set your value
2) in solution initialization you should comupte from inlet.
hope that will help you
Last edited by dynamicdom; February 25, 2010 at 09:16. Reason: i posted in wrong thread! :-x
|Thread||Thread Starter||Forum||Replies||Last Post|
|Setting dynamic pressure as the inlet BC||ruined||FLUENT||1||March 26, 2008 06:30|
|Setting static pressure as the inlet BC||ruined||FLUENT||1||March 21, 2008 15:57|
|High pressure concentration results @ the inlet||Kuh||CFX||0||June 24, 2007 23:42|
|Pressure Inlet Boundary Condition||Trinity_psu||FLUENT||0||June 1, 2005 14:15|
|Gas pressure question||Dan Moskal||Main CFD Forum||0||October 24, 2002 22:02|