[GAMBIT] Need Help

hadi1984 · February 3, 2010, 01:48

Hi, I am working with GAMBIT & FLUENT. I'd like to anlysis a fin-tube in heat transfer. I use Tri/Pave model for mesh in front and back sides in inner part and then use cooper mesh for volume mesh. When I gird check in FLUENT it has 2 errors and I don't understand the meaning of them:

1-outflow zone 6 has two adjacent cell zones.
2-mass-flow-inlet zone 8 has two adjacent cell zones

and because of these two reasons Grid check will fail.

Whould you please help me to know these 2 errors and how I can remove them.

Thanks

-mAx- · February 4, 2010, 00:52

post a picture of your geometry in the neighborhood from your inlet and outler.

February 3, 2010, 01:48	Need Help	#1
hadi1984 New Member Hadi Join Date: May 2009 Posts: 7 Rep Power: 16	Hi, I am working with GAMBIT & FLUENT. I'd like to anlysis a fin-tube in heat transfer. I use Tri/Pave model for mesh in front and back sides in inner part and then use cooper mesh for volume mesh. When I gird check in FLUENT it has 2 errors and I don't understand the meaning of them: 1-outflow zone 6 has two adjacent cell zones. 2-mass-flow-inlet zone 8 has two adjacent cell zones and because of these two reasons Grid check will fail. Whould you please help me to know these 2 errors and how I can remove them. Thanks

February 4, 2010, 00:52		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	post a picture of your geometry in the neighborhood from your inlet and outler. __________________ In memory of my friend Hervé: CFD engineer & freerider