CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] ICEM CFD Boundary Conditions not found in Ansys Fluent (http://www.cfd-online.com/Forums/ansys-meshing/74850-icem-cfd-boundary-conditions-not-found-ansys-fluent.html)

sammyraj April 9, 2010 17:11

ICEM CFD Boundary Conditions not found in Ansys Fluent
 
Hi all,

I am doing a 2 D project which involves flow through two annular nozzles. I am new to ICEM CFD and I have simple problem.And help will be much appreciated.

I created geomtry and also meshing. Also I gave BC's in icem cfd and when I tried to read the mesh in Ansys fluent ,the BC's were not found. Fluent was able to read the mesh but not the B.C's. I have given Bc's by creating new part and giving names.

rwryne April 12, 2010 08:28

You have to assign actual boundary conditions to your named parts.

Follow the steps in this post: http://www.cfd-online.com/Forums/ans...tml#post230872

sammyraj April 12, 2010 15:23

Hi Ryne,

Thanks a lot!!
I should have searched the forums before asking and I think I assigned B.c's after meshing. So I am gonna change that.

anyways please allow me ask one more question .
I have solve a problem which involves flow through two annular nozzles, I am not sure about mesh yet although I was able to read in Fluent. Can you guide me the best way to mesh also creating surfaces http://i19.photobucket.com/albums/b1.../geomtry-1.png


All times are GMT -4. The time now is 13:01.