CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   How to mesh a swept wing in ICEM? (http://www.cfd-online.com/Forums/ansys-meshing/75406-how-mesh-swept-wing-icem.html)

kepeng April 24, 2010 12:34

How to mesh a swept wing in ICEM?
 
2 Attachment(s)
Hi, every one.
I currently try to mesh a swept wing, with the airfoil of NACA65a008, where the trailing edge is just a line. firstly, i split it into a O-grid, then split it into 3 part along in spanwise. Finally i got a very bad quality mesh, especially near the wing tip and root, where is just triangle near the trailing edge.

could somebody give me some advise on how to mesh a swept wing? Thanks a lot.

the geom and mesh is attached.


All times are GMT -4. The time now is 13:34.