 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2010, 14:30
|
Setting Boundary Conditions
|
#1 |
|
New Member
Patrick Young
Join Date: May 2010
Posts: 15
Rep Power: 15  |
I'm following this tutorial ( https://confluence.cornell.edu/displ...pe+Flow+Step+3 ) which was written for Gambit. I am working in ICEM. I can't figure out how to apply the boundary conditions (velocity inlet, pressure outlet, axis wall).
I set my solver to Fluent 6, and went to Output --> Boundary Conditions. In this window, I went to Mixed/Unknown-->GEOM-->Create New, and created the boundary condition "velocity inlet" and it asked me to specify a zone. I don't know what the zones are, or how to specify them. Thanks for your time. |
|
|
|
|
|
May 10, 2010, 21:12
|
|
#2 |
|
New Member
Brian Polly
Join Date: Feb 2010
Posts: 26
Rep Power: 16 |
Search for ICEM on youtube, some very nice tutorials.
|
|
|
|
|
|
|
June 8, 2010, 20:29
|
Default zone.
|
#3 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Just ignore the zones (leave them as zero). Those get more important if you are doing fancy things such as a rotating zone within a static zone...
If they are all set to zero, then they are all part of the same zone (zone 0, the default zone). Best regards, Simon |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
| Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
| symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
| question setting up airfoil Boundary Conditions | ibzyuk | FLUENT | 0 | April 9, 2010 07:47 |
| Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Linear Mode
