CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   divide a face in order to have different boundary conditions (http://www.cfd-online.com/Forums/ansys-meshing/76500-divide-face-order-have-different-boundary-conditions.html)

antonio May 27, 2010 05:24

divide a face in order to have different boundary conditions
 
Hi all.:)

I have a rectangular box.I pretend to divide the bottom in two different zones in order to give them different boundary conditions in these zones. I am not being able to do that. Does anyone have a suggestion to do that?

Best Regards.

kepeng May 27, 2010 06:17

In ICEM, just to set different face with different part name.
btw, it is very easy to do so in Fluent. Select the menu "grid", then "separate"

antonio May 27, 2010 06:21

Sorry,

I forgot to mention that I am using CFX

Regards

antonio June 7, 2010 05:37

Hi all.
If anyone have a similar case to mine you can divide the bottom of the channel using the Operation Imprint Faces in the extrude feature from the 3D features toolbar.

Regards


All times are GMT -4. The time now is 05:15.