|
[Sponsors] |
August 23, 2012, 16:00 |
why is this happening ?
|
#1 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
problem is described in the picture above,
i searched all over the forum, i turned on thin cut, adjusted edge criterion, still get this. anyone has an idea ? |
|
August 24, 2012, 01:28 |
|
#2 | |
New Member
nitin bansal
Join Date: Jun 2012
Location: INDIA
Posts: 27
Rep Power: 13 |
Quote:
Try rechecking association and edge association methods method.... Can you more specific about the geometry |
||
August 24, 2012, 05:34 |
|
#3 |
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 21 |
It looks like you have an inside curve which is not relevant. have you done a build topology before meshing ?
|
|
August 24, 2012, 10:44 |
|
#4 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
thanks for replying,
for the building topology, it is showing me yellow curve. but i don't know which feature to check there when it comes to curves like this. @nitin the picture below describes my geometry better, look inside the red bubble: |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running dieselFoam error | adorean | OpenFOAM Running, Solving & CFD | 119 | February 1, 2016 15:41 |
What's happening with residuals? | plm | OpenFOAM Running, Solving & CFD | 2 | January 27, 2012 04:21 |
[snappyHexMesh] SnappyHexMesh STL patch naming | gregorv | OpenFOAM Meshing & Mesh Conversion | 1 | July 23, 2008 08:05 |
What is happening with RMS values | nobody | CFX | 6 | April 1, 2008 18:52 |
What is happening here | IOC | FLUENT | 3 | March 19, 2008 18:05 |