Wind tunnel hexa meshing in ICEM CFD 12.1

matheusguzella · February 24, 2011, 09:16

Hello,

I'm using ICEM CFD 12.1 for meshing a wind tunnel with hexa elements.. but I don't know (I don't have much experience with hexa meshing) how to make to correct associations, since I'm using only half of the model (as can be checked on the file attached).. I'm meshing this model for a project on my university, I tried to see the tutorial but I couldn't solve this problem..

Best Regards,

Matheus Guzella

PSYMN · March 14, 2011, 16:14

If you took the section 45 degrees from this one, it would have 4 good corners and would be much easier to hexa mesh than this triangular section...

However, you can still handle this triangular section with a quarter ogrid (aka Ygrid) or wedge (collapsed hexa) topology...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
inflation layers for hexa mesh using icem cfd	Apple	CFX	4	January 6, 2012 00:12
simulate wind tunnel and meshing....need some help	ACER	FLUENT	0	December 27, 2010 16:02
Hexa ICEM CFD	Amit	CFX	3	July 28, 2008 18:48
Hexa Meshing with ICEM & CFX	Matias	CFX	2	May 9, 2007 19:57
Comparing wind tunnel tests costs with CFD	Freeman	Main CFD Forum	9	January 30, 2006 08:02

March 14, 2011, 16:14		#2
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	If you took the section 45 degrees from this one, it would have 4 good corners and would be much easier to hexa mesh than this triangular section... However, you can still handle this triangular section with a quarter ogrid (aka Ygrid) or wedge (collapsed hexa) topology...