CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Defining the surfaces in ANSYS 12.1 (http://www.cfd-online.com/Forums/ansys-meshing/78133-defining-surfaces-ansys-12-1-a.html)

ATOTA July 13, 2010 18:40

Defining the surfaces in ANSYS 12.1
 
Hello,
I have a little problem with ANSYS workbench 12.1. I am new to this program. I was using Gambit before. I want to define the surfaces as velocity_inlet, outlet, symmetry, and etc. This was easy in Gambit but I can't figure out how to do it in ANSYS workbench. Could anyone enlighten me ??

Thanks:)

PSYMN July 15, 2010 21:07

Named Selections
 
Ah, I keep getting reminded to make a short movie about this... Perhaps I will tomorrow afternoon. it is a good Friday afternoon task if I can get some critical things out of the way first.

The secret is "Named Selections"...

I have posted about this a bunch of times, so just search for that phrase.

ATOTA July 16, 2010 11:36

Thanks a lot ! :-)


All times are GMT -4. The time now is 20:43.