|July 16, 2010, 05:43||
Meshing a Flat Delta Wing
Join Date: Jul 2010
Posts: 18Rep Power: 6
I am working on a problem dealing with a flat delta wing of root chord 400 mm. Its my first go on Ansys and so far Ive managed to model the geometry.
I've also meshed the figure but the quality appears to be bad, although positive. I am trying to improve the quality to above 20%. Can anyone please suggest alternative methods to improve quality? Also, if you know about any particular blocking strategy that works well for Delta wings, please let me know.
I have just about a month and half to complete this project. Any help would be much appreciated.
I've attached an image of my geometry. Please ask me if any more information is required.
|blocking, blocking strategy, delta wing, meshing, quality|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Problems about meshing the swept wing with cylinder end cap||kepeng||ANSYS Meshing & Geometry||3||June 15, 2010 05:21|
|Delta wing problem||extraliu||CD-adapco||0||April 27, 2010 14:40|
|Plotting Cp vs z-cordinate on Delta Wing||Shamoon||FLUENT||0||December 31, 2007 09:31|
|Delta Wing Structured Grid||Riaan||FLUENT||3||December 31, 2004 12:03|
|How to mesh a delta wing in the middle of a sphere||David||FLUENT||0||September 2, 2004 13:19|