|
[Sponsors] |
[DesignModeler] In mesh tool, a line within geometry does not appear |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 1, 2013, 13:30 |
In mesh tool, a line within geometry does not appear
|
#1 |
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 12 |
Hello everyone,
I am trying to model a 2D geometry in Design Modeler (please see the attached image). I want to assign inlet in the line situated inside the geometry. But when I import this geometry in meshing tool, it just shows the whole body, I can't see the middle line , so I can't select it for named selection (see attached image). How can I draw such a geometry so that I can select the middle line within the geometry? Please help me out. Thanks in advance. |
|
July 2, 2013, 02:18 |
|
#2 |
Senior Member
|
That is just a line in a sketch and won't be visible in the meshing application. Look into extruding this sketch line with the option to imprint on your 2d face (in DM)
|
|
July 3, 2013, 10:33 |
request for detail explaination
|
#3 |
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 12 |
Hi, Thanks for your reply. Unfortunately I couldn't get your answer properly. Could you explain a little bit?
I tried to extrude the line (within the rectangle box) , it shows me yellow tick with "done" message. If I give "yes" to "it is thin/surface" then it shows greem tick. But I couldn't find any imprint option . |
|
July 3, 2013, 17:32 |
Model information is incompatible with upcoming mesh
|
#4 |
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 12 |
Hi, finally I am able to naming edge. Thank you. I checked "through all" in extent type. Is it okay? After naming the all the edge I want, when I try to open fluent, it says me "model information is incompatible with upcoming mesh" and it says that it can't found some zone. Please see the attached image. What can I do to solve this problem? Please help me out.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Meshing Strategy for inside geometry | powpow | ANSYS Meshing & Geometry | 6 | January 16, 2013 04:32 |
8x icoFoam speed up with Cufflink CUDA solver library | kmooney | OpenFOAM Running, Solving & CFD | 42 | November 6, 2012 11:37 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |