CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Offset boundary on surface (http://www.cfd-online.com/Forums/ansys-meshing/78686-offset-boundary-surface.html)

gnuboard July 29, 2010 12:22

Offset boundary on surface
 
Hi everybody,

I'm sure that this is a really simple problem, but i dont find the ways to disable the offset option on the surface boundary.

I want a tri only surface mesh, but icem create three layer of quad on all the line.

The option "All Tri" is activated in the surface global parameter.

Thanks

PSYMN July 30, 2010 08:53

Width set to "3"
 
You must have "width" set to "3" for those curves. Check your curve params or your "Params by Parts".

Simon

gnuboard July 30, 2010 10:59

You are right.


best regards

Etienne


All times are GMT -4. The time now is 17:11.