|July 29, 2010, 12:22||
Offset boundary on surface
Join Date: May 2010
Posts: 7Rep Power: 8
I'm sure that this is a really simple problem, but i dont find the ways to disable the offset option on the surface boundary.
I want a tri only surface mesh, but icem create three layer of quad on all the line.
The option "All Tri" is activated in the surface global parameter.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Error : Self intersecting surface mesh, computing intersections & Error : Impossible||velan||Open Source Meshers: Gmsh, Netgen, CGNS, ...||3||October 22, 2015 11:05|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|boundary condition at free surface||mike||NUMECA||3||June 8, 2006 06:23|
|New topic on same subject - Flow around race car||Tudor Miron||CFX||15||April 2, 2004 06:18|
|Velocity on Free Surface Boundary||Lin F.F||Main CFD Forum||3||August 4, 2001 11:30|