[ICEM]How to use prism layers properly?

Prediger · August 20, 2010, 05:49

Dear All!

I’m new with ICEM going through tutorials but I’m stuck. I have to have prism layers in the inlet surface of a pipe but instead I have them in the cylindrical shell. What did I do wrong with the settings?

Thanks!

BrolY · August 20, 2010, 05:54

I guess your inlet is where the flow is coming from. It means that the flow is perpendicular to the inlet. Am I right? If yes, you can't have prism layers on your inlet :
The prism layers are used to simulate the boundary layer, so it's logical that you have prism layers in the cylindrical shell, but not logical to have prism layers on your inlet.

August 20, 2010, 05:49	[ICEM]How to use prism layers properly?	#1
Prediger New Member Join Date: Jul 2010 Posts: 1 Rep Power: 0	Dear All! I’m new with ICEM going through tutorials but I’m stuck. I have to have prism layers in the inlet surface of a pipe but instead I have them in the cylindrical shell. What did I do wrong with the settings? Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Prism Layers in the corner	bengy	STAR-CCM+	19	August 1, 2016 06:46
[ICEM] Prism layers around interior wall	rwryne	ANSYS Meshing & Geometry	18	February 1, 2013 10:57
Getting prism to inflate into mixed tet-hex meshes	Joe	CFX	16	October 10, 2011 07:06
ICEM Prism Layer transition between surface with prism layers and one without	TWaung	ANSYS Meshing & Geometry	2	October 12, 2009 14:56
Icemcfd: Preventing prism inflation collisions?	Joe	CFX	1	July 31, 2007 09:13

August 20, 2010, 05:54		#2
BrolY Senior Member AB Join Date: Sep 2009 Location: France Posts: 323 Rep Power: 21	I guess your inlet is where the flow is coming from. It means that the flow is perpendicular to the inlet. Am I right? If yes, you can't have prism layers on your inlet : The prism layers are used to simulate the boundary layer, so it's logical that you have prism layers in the cylindrical shell, but not logical to have prism layers on your inlet.